Series 100 Temporary Power Bypass

The following links will display the wiring diagrams of the Power (Rear) Circuit Board and show the power and pump connections.Please click on the model you have:

SBX-100

Turn off the circuit breaker to the pool equipment. Indentify each wire. Then remove the wire on Pin 5 and put a wire nut on it. Remove the wires on 1 and 4 and wire nut them together. Remove the wires on 3 and 6 and wire nut them together. When the circuit breaker is turned on, the pump will run in high speed.

SBX-101

Turn off the circuit breaker to the pool equipment. Indentify each wire. Then remove the wire on Pin 6 and put a wire nut on it. Remove the wires on 1 and 4 and wire nut them together. Remove the wires on 3 and 5 and wire nut them together. When the circuit breaker is turned on, the pump will run in high speed.

SBX-102

Turn off the circuit breaker to the pool equipment. Indentify each wire. Then remove the wire on Pin 6 and put a wire nut on it. Remove the wires on 1 and 4 and wire nut them together. Remove the wires on 3 and 5 and wire nut them together. When the circuit breaker is turned on, the pump will run in high speed.

SBX-102A

Turn off the circuit breaker to all the pool equipment. Identify each wire. Then remove the wires from terminal 1 and install it on terminal 5. Remove the wire from terminal 2 and install it on terminal 6. Make sure all terminals are tightened and wires are held securely in place. Terminals 5 & 6 will each have two wires installed on them. When the circuit breker is turned on the pump will run in high speed.